Film and developing — complete
| Item | Notes |
|---|---|
| Paterson Multi-Reel 3 tank (PTP116) | Holds 3× 35mm or 2× 120 |
| Paterson auto-load reels ×3 | Adjust between 35mm and 120 |
| MOD54 4x5 insert | Not usable for 124 — see the 124 reel |
| Ilford HP5 Plus 400, 120 ×3 | |
| Ilfosol-3 developer, 500 mL | One-shot, 10 rolls’ worth |
| Ilford Rapid Fixer, 1 L | Film and paper, at different dilutions |
| Ilfostop, 500 mL | Film and paper, same dilution |
| Sensei changing bag, 27×30” | Right size for wrestling 120 |
| CineStill accordion bottles, 1 L ×3 | See assignments below |
| Paterson film clip set | Weighted + plain clips; also dries prints |
| 1000 mL glass beaker | Mixing working solution |
| 100 mL glass graduate | Measuring concentrate |
| High-res thermometer |
Printing — ordered or on hand
| Item | Notes |
|---|---|
| Photographers’ Formulary 8×10 contact print frame | Spring back holds curly vintage film flat |
| Paterson 8×10 trays ×3 | Developer, stop, fixer |
| Samigon bamboo tongs ×3 | One per tray, never swapped |
| Ilford Multigrade filter set, 6×6” (12) | Contrast control — see contact printing |
| Ilford Multigrade developer, 500 mL | Paper developer |
| Ilford Multigrade RC Deluxe Pearl, 5×7, 100 sheets | Starter paper |
| Flic Film red LED safelight bulb | Fog-test before use (contact printing) |
| DiCUNO pendant cords with inline switch ×2 | One exposure light, one safelight |
| 25W A19 incandescent, warm white | Exposure light; filter grades behave as labeled |
| Timer | Tape over any lit display (contact printing) |
Bottle assignments
- Film fixer working solution (1+4). Mix 1 L at a time so the bottle starts completely full.
- Stop working solution (1+19), shared by film and paper.
- Ilfosol-3 concentrate, decanted once the original is half gone. Collapse the bottle as the level drops.
- Optional — paper fixer (1+9). Not needed: RC paper can use bottle 1 (1+4) for 30 s (contact printing). Use a separate bottle only if you print a lot.
Multigrade developer concentrate stays in its own bottle. Mix its working solution fresh each printing session.
Still need
- Anti-static brush or air blower
- Scissors — trimming film corners before loading
- Cotton gloves for handling the vintage negatives
A phone is fine as a timer for film developing, which happens in room light. Don’t use it in the printing darkroom, where the screen can fog paper. Use the timer there.
Wetting agent
- Ilfotol, used at 1+200 in RO/DI water for the final rinse (developing, Step 8). Measure it with a 5 or 10 mL syringe, because the amounts are tiny.