Developing film

Loading the tank: 120 and 620

The hard part: getting film onto a Paterson reel in a changing bag, in total darkness.

What happens in the dark vs. the light

The changing bag is used for one step only: getting film onto the reel and into the sealed tank. Once the lid is locked, the tank is light-tight and everything else happens at the sink in normal room light.

Into the bag: film roll, dry reel, center column, tank body, tank lid, scissors.

In the dark: separate film from backing paper → load reel → reel onto column → column into tank → black outer lid on and locked.

Out of the bag: the sealed tank, scraps, scissors.

A red safelight is not safe for this step. HP5 and Verichrome Pan are panchromatic, which means they’re sensitive to red light. Load them in total darkness or in the bag. A red safelight is only for paper and for the ortho Plenachrome (the vintage 124 rolls).

Lid anatomy

  • Black outer lid — the light seal. Locks on before the bag opens, comes off only after fixing.
  • Red center cap — pops out to pour chemistry in and out. Keep it seated during inversions or developer goes across the room.

Loading procedure Total darkness (changing bag)

Practice with a sacrificial roll in daylight first, and expect to sacrifice that roll learning with the lights on.

  1. Reels must be bone dry. A damp reel jams the film halfway, and you can’t fix that blind. Dry reels overnight or with a hairdryer on cool.
  2. Set the reel width to 120 — twist the two halves in opposite directions and pull apart until they click at the wide setting.
  3. In the changing bag: break the seal, unroll. The film is taped to the backing paper at the far end.
  4. Separate film from paper as you go. Film curls emulsion side in (the dull side faces in).
  5. Trim the leading corners slightly rounded with scissors. Square corners snag. Save the trimmed corners in a small jar. They’re your clip-test scraps.
  6. Feed into the ball-bearing entry, then walk the reel halves back and forth to ratchet the film in.
  7. When you reach the tape, peel or cut it off and finish winding.
  8. Reel onto column, column into tank, lid on and locked before the bag opens.

If it binds, don’t force it. Back the film out a few inches and re-feed.

620: it’s the same film as 120 on a thinner spool, so load it exactly the same way. The spool never goes in the tank; set it aside for the camera.