The camera is native 124 (3¼ × 4¼). Your spool adapters extend a 120 spool to the 3.716” length the chamber needs — they solve length, not width.
What you get
- 120 film is 61mm wide; the gate is ~83mm. Your frame is 61 × 108mm — a panoramic crop of the native format.
- 6 frames, possibly 7 if you wind tightly. 120 is ~820mm of film and each frame eats ~108mm plus a gap.
- Both the supply spool and the take-up spool need adapters. Four pieces, two per spool.
Orientation — which finder to use
The camera has two finders for two orientations. Orientation does not change the crop. The narrowing always happens across the film’s width, so you get 61 × 108mm either way; holding the camera differently only rotates the frame.
| Held | Result | Good for |
|---|---|---|
| Horizontal | Wide 108 × 61 | Landscapes, groups |
| Vertical | Tall 61 × 108 | Portraits and selfies |
61:108 is almost exactly 16:9, so in vertical orientation you’re shooting a phone-screen aspect ratio on 1910 hardware. For the self-portrait project that’s the thesis built into the geometry. Use the vertical finder.
With actual 124 the frame is 3¼ × 4¼ (about 1:1.31), so vertical gives you 3:4, the classic portrait ratio. Faces still want vertical, but it’s less decisive.
Red window check — do this first
The window is positioned for 124 backing paper. Narrower 120 paper may not cover it.
- Load an empty/sacrificial roll, close the back.
- In bright light, look for any light coming through the window from inside — or shine a flashlight at the window in a dark room and look for leakage past the paper edge.
- If light gets through, tape it over with gaffer or electrical tape. That window is a direct hole to your film.
Winding without the window
Frame numbers won’t align even if the window does land on paper — 120 has three number rows for 6×9, 6×6, and 6×4.5, none matching the No. 3’s spacing.
- Wind by counting turns. Note what you use on roll one and adjust.
- Starting point: wind until you feel the paper leader take up, then count roughly 1½ full turns between frames, decreasing slightly as the take-up roll grows in diameter.
- Log every frame’s wind count in a notebook. Roll one is calibration.
Other prep
- Matte black tape on the bare interior walls beside the gate cuts flare from the extra chamber width.
- Loading and unloading happen in daylight — the backing paper seals the roll. Shade, not direct sun.
- Check the shutter fires on both settings and the lens is free of haze before wasting film.
Developing it
You’re shooting standard 120, so it develops on the reels you already have using the developing recipe exactly as written. No special handling.